Rack Back Panels
- Standard sized panels 4′-0″ or 5′-0″ high, match beam length in width.
- Custom size panels available.
- Panels made of 2″ x 2″ x 10 gauge welded wire mesh.
- Flat steel stiffeners welded behind mesh for extra rigidity.
- Pallet Rack Backing Panels attach directly to rack with mounting brackets.
- Multiple attachment points (seven) on ends of each panel.
- Offset brackets allow for load to overhang rack beams.
- Stack Rack Back panels one on top of the other to reach desired height.
- “Above the Top” mounting allows panels to extend above top rack beam.
- Angle frame design gives installer clear access to hardware, speeding installation.
- Assembly hardware is inaccessible from the exterior of the partition.
- Standard 3/8″ assembly hardware is the heaviest in the industry.
- Rack Back Pallet Rack Backing System may be started at the floor or at any level where protection is required.
- Pallet rack backing panels can be mounted to support posts-if stand alone system desired.
- Heavier options available.
| Four Foot High Panels | Five Foot High Panels |
| Width x Height | Weight (lbs.) | Width x Height | Weight (lbs.) |
| 6′-0″ x 4′-0″ | 27 | 6′-0″ x 5′-0″ | 31 |
| 7′-0″ x 4′-0″ | 34 | 7′-0″ x 5′-0″ | 39 |
| 8′-0″ x 4′-0″ | 40 | 8′-0″ x 5-0″ | 46 |
| 9′-0″ x 4′-0″ | 44 | 9′-0″ x 5′-0″ | 51 |
| 10′-0″ x 4′-0″ | 47 | 10′-0″ x 5′-0″ | 55 |
| 12′-0″ x 4′-0″ | 74 | 12-0″ x 5′-0″ | 84 |
